Trailing Edge Of Stapled Sheets Close To The Paper Exit - Ricoh Pro C651EX Troubleshooting Manual

5.1.3 Trailing edge of stapled sheets close to the paper exit

Cause:
If the stapled sheets are curled strongly or become limp after delivery, the trailing
edge of the sheets may be too close to the paper exit when the paper is stacked.
If this happens, stapled sheets, when delivered, may push the previously delivered
sheet, resulting in paper bending or misfeeding.
This is likely to occur if:
• There is a tight curl on a delivered set of stapled sheets.
• Limp paper such as thin or recycled paper is used.
Output tray
Paper feed direction
Solution:
1. Attach the Z-fold support tray.
2. Print the image. Is the problem resolved?
Yes Finished!
No Go to the next step.
To follow the steps below, attach the decurler unit.
3. In the [Adjustment Settings for Skilled Operators] menu, set [0116: Adjust
Paper Curl] to "Adjust
Select "Strong" or "Weak" to control the level of decurling as required.
4. Print the image. Is the problem resolved?
Yes Finished!
No Contact your service representative.
Note:
• For details about attaching the Z-fold support tray, see "When Z-folded Paper Is
Not Properly Aligned" in the Troubleshooting supplied with the machine.
• If the Z-fold support tray is attached, the trailing edge of the ejected sheets will
not be too close to the paper exit, so no problem will occur. However, the stapled
sheets may not be stacked properly.
Trailing edge
too near exit
Paper exit
Curl".
CEZ593
124