Paper Edges Are Soiled (3) - Ricoh Pro C651EX Troubleshooting Manual

4.8.8 Paper Edges Are Soiled (3)

40 mm
(1.6 in.)
Cause:
The paper feed speed of the decurler unit is too high.
Note:
• To adjust the following settings, pre-register the type of paper in use as a custom
paper. For details about registering custom papers, see "Registering a Custom
Paper", Paper Settings Reference.
• Decreasing the paper feed speed of the decurler unit may result in creases,
scratches, or paper jams if thin paper is used.
Solution:
You can lessen the problem by decreasing the paper feed speed of the decurler
unit.
1. In the [Adjustment Settings for Skilled Operators] menu, check the present
degree of decurling (Off, Weak, or Strong) in [0116: Adjust Paper Curl].
2. In [Advanced Settings] for the custom paper in use, adjust the paper feed
speed of the decurler unit.
• If the degree of decurling is set to "Off", reduce the value in [51: Decurler
Feed Speed Adj: Curl Adj Off] by 0.5%.
• If the degree of decurling is set to "Weak", reduce the value in [52: Decurler
Feed Speed Adj: Curl Adj Weak] by 0.5%.
• If the degree of decurling is set to "Strong", reduce the value in [53:
Decurler Feed Speed Adj: Curl Adj Strg] by 0.5%.
3. Print the image. Is the problem resolved?
Yes Finished!
No Keep decreasing the value by 0.5% until the problem is resolved.
If the problem persists even though the setting has reached its
minimum value, contact your service representative.
120 mm
(4.8 in.)
CNT014
101