Ricoh Pro C651EX Troubleshooting Manual page 135

<When letter folding is applied to a single sheet>
Note:
• This procedure is applied especially to coated paper.
• To adjust the following settings, pre-register the type of paper in use as a custom
paper. For details about registering custom papers, see "Registering a Custom
Paper", Paper Settings Reference.
1. In [General Features] in [System Settings], set [Letter Fold-in Position] for a
single sheet to "7 mm".
2. In [Advanced Settings] for the custom paper in use, select [59: Letter Fold-in
Position 1: Single-sheet Fold].
3. Increase the value by 0.2 mm.
4. Print the image. Is the problem resolved?
Yes Finished!
No Repeat Step 2 to 4. If the problem persists even though the setting
value is 4 mm larger than the maximum value, contact your service
representative.
135