Nortel CS 1000M HG Manual page 40

40 Installation and configuration
2. Plan the superloop and fiber-optic link configuration based on the traffic
3. Install the NT8D04 Superloop Network card into a network card slot
4. Configure and install the Fiber Remote Multi-IPE Interface unit. Refer
5. Connect the system monitor, local MMI terminal, and fiber-optic link
6. At the remote site, install the Remote IPE equipment. Refer to the
Copyright © 2007, Nortel Networks
.
requirements (blocking or non-blocking traffic) at the Remote IPE site.
Refer to the following:
• "Engineering guidelines" (page 31)
• Table 2 "Superloop connection configurations" (page 16)
the number of superloops required
• Table 3 "Equipment required to link local system to Remote IPE
sites" (page 18) to select the appropriate Fiber Remote Multi-IPE
Interface type based on the number of superloops and the fiber-optic
cable type
and connect the internal superloop cables to the network I/O panel. To
identify an empty network card slot, refer to the following:
• Table 8 "Modules supporting Superloop Network cards" (page 46)
• "Installing the Superloop Network card" (page 47)
into its designated card slot
• "Installing cables between the Superloop Network card and the
network I/O panel" (page 48)
faceplate connectors and the network I/O panel
to the following:
• "Setting S1 and S2 switches at the local site" (page 48)
dip-switches S1 and S2, to install the redundant optical connectors,
if required, and to install the unit onto the wall or into the shelf
• "Installing local superloop cables" (page 61)
between the network I/O panel and the SUPERLOOP connectors
on the Fiber Remote Multi-IPE Interface unit
cables to the Fiber Remote Multi-IPE Interface unit connectors. Refer
to the following:
• "Connecting local system monitor cables" (page 62)
• "Connecting the SDI card and the MMI terminal to multiple Fiber
Remote Multi-IPE Interface units" (page 67)
•
"Connecting the fiber-optic link" (page 69)
following:
•
"Installing the internal cables to the Remote IPE module" (page 77)
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 01.01 Standard
Release 5.0 30 May 2007
to install cables between J1 and J2
to connect the cables
to specify
to install the card
to set the