Performing A Call Hold/Call Retrieve Test - Nortel CS 1000M HG Manual

108 Remote IPE acceptance testing
2
3
4
Call hold/call retrieve
Call hold is used to place an active call on hold in order to answer an
incoming call or place an outgoing call. After releasing an incoming or an
outgoing call, the call on hold can be retrieved.
To perform a call hold/call retrieve test, follow the steps in
"Performing a call hold/call retrieve test" (page
Procedure 30

Performing a call hold/call retrieve test

Step
1
2
3
4
5
6
7
8
9
10
Copyright © 2007, Nortel Networks
.
Verify voice transmission by talking with the person at the other
telephone. Make sure the speech is clear in both directions.
Maintain the connection and ask the person at the remote site to test
basic calling features such as call hold/call retrieve.
Terminate the call.
Action
From a telephone at the local site, dial a telephone at the Remote
IPE site and establish an active call connection.
Verify voice transmission by talking with the person at the other
telephone.
Press the Hold key at the remote site to place the active call on hold.
Note: To find out how to use the feature keys on different
telephones, consult the user manual supplied with the telephone.
Now, place an outgoing call from the telephone at the remote site by
dialing an idle telephone located at the local site.
Complete this outgoing call by first checking the voice clarity in both
directions, and hang up.
Have another telephone call while the first call is still on hold.
Answer the incoming call and place it on hold.
Retrieve the call first held.
Complete the call and hang up.
Retrieve the second call on hold.
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 01.01 Standard
Release 5.0 30 May 2007
—End—
108).
Procedure 30