Displaying Alarm And Error Logs To Check The Performance History - Nortel CS 1000M HG Manual

Procedure 41

Displaying alarm and error logs to check the performance history

Step
Display Alarm:
This procedure uses MMI commands to display the superloop and the
fiber-optic link performance history.
1
2
3
Copyright © 2007, Nortel Networks
.
Action
Log in on the MMI maintenance terminal.:
FII:: >L
Enter Password > FIBER
Type D A [P] (DISPLAY ALARM) to display near-end superloop
and fiber-optic link alarm history. Type D A D (DISPLAY ALARM
DISTANT) to display far-end superloop and link alarm history. The
[P] or pause, allows a display of a full screen of events at the time.
The response is displayed on the screen and shows the time and
date,
of each alarm or error event.
Example:
FII::>D A
Fiber Remote IPE S/N 2502-R3 Software Version 3.11 5/15/96
10:45
Local Site
In Alarm State: NO (superloops are not in the alarm state)
01/22/96 09:26 No Activity Superloop 1
01/22/96 09:26 Activity On Superloop 1
01/22/96 09:25 No Activity Superloop 1
01/22/96 09:25 Activity On Superloop 1
01/22/96 09:24 No Activity Superloop 4
01/22/96 09:20 No Activity Superloop 3
01/22/96 09:17 Activity On Superloop 4
01/22/96 09:17 Activity On Superloop 3
01/22/96 09:17 Activity On Superloop 2
01/22/96 09:17 Fiber Link Up
01/22/96 09:16 Fiber A Threshold Exceeded
01/22/96 09:16 Fiber Link Down
01/22/96 09:15 Performed a Power Up Reset
01/22/96 09:15 Initialized Memory
01/22/96 09:10 Log Cleared
Clear the near-end (local) alarm log by executing the C AL (CLEAR
ALARM) and the far-end (remote) by executing the C AL D (CLEAR
ALARM DISTANT) command.
Nortel Communication Server 1000
Fiber Remote Multi-IPE Interface Fundamentals
NN43021-556 01.01 Standard
Release 5.0 30 May 2007
Remote IPE fault isolation and correction 135
Login command
Type in the password.