To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Hot Surface Indicator Light Removal
Condition Requirements:
Glass Top Removed
1. Remove two screws and light bracket from range.
2. Mark and disconnect two connectors from surface
indicator light.
3. Press tabs on side of surface indicator light to
remove from bracket.
4. Reverse procedure for installation.
Side Panel Removal
Condition Requirements:
Control Panel Assembly Removed
1. Remove two screws and lift kick plate from keyhole
screws.
©2009 Viking Preferred Service
2. Remove fi ve screws and side panel from range.
3. Reverse procedure for installation.
Hinge Receiver Removal
Condition Requirements:
Door Assembly Removed
Side Panel Removed
1. Remove three screws and side trim from range.
2. Remove fi ve screws and panel from range.
Disassembly
39