Motor Capacitor Removal; Door Assembly Removal; Door Gasket Removal - Viking VESC530 Service Manual

Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Motor Capacitor Removal

Condition Requirements:
Control Board Accessed
1. Mark and disconnect wires from capacitor.
2. Remove nut, lockwasher, and capacitor from lower
mounting plate.
3. Reverse procedure for installation.

Door Assembly Removal

Condition Requirements:
Door Lowered
1. Place pins supplied with unit in pin holes.
Note: For personal safety, only use pins supplied with
unit.
2. Remove screws and hinge trim from range.
3. Close door until pins stop door.
28
4. Lift door up and out.
Door Assembly
Note: If the door needs to be adjusted, loosen hinge
trim screws. Adjust the screws located between
the door and kick plate using a
allen wrench. Tighten hinge trim screws after
adjustment is made.
5. Reverse procedure for installation.

Door Gasket Removal

Condition Requirements:
Door Lowered
1. Insert a narrow tool or small fl at-blade screwdriver
into the center of each clip and pry upward.
2. Remove the door gasket from two holes in the bottom
of the door liner.
3. Reverse procedure for installation.
Adjustment Screw
/ " hex head
5
32
©2009 Viking Preferred Service