Oven Light Bulb Removal; Top Light Housing Removal; Side Light Housing Removal; Oven Cycle/Clean And Surface Power On Indicator Light Removal - Viking VESC530 Service Manual

Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Oven Light Bulb Removal

Condition Requirements:
Door Lowered
DO NOT touch bulb with bare hands. Clean off any
signs of oil from the bulb and handle with a soft cloth.
1. Unsnap glass light cover using a screwdriver in the
access groove.
2. Firmly grasp light bulb and pull out.
3. Replace with halogen bulb using volt and wattage
requirements listed on glass cover.
4. Replace the light cover by snapping glass cover onto
metal box.
1
3

Top Light Housing Removal

Condition Requirements:
Door Assembly Removed
Control Panel Assembly Removed
1. Remove lens and bulb.
2. Disconnect connector for top light.
3. Use a screwdriver to depress two tabs in top light
housing and tilt front of housing down to remove.
4. Reverse procedure for installation.
36
2
4

Side Light Housing Removal

Condition Requirements:
Door Assembly Removed
Control Panel Assembly Removed
1. Remove screw and side light housing from oven liner.
2. Disconnect connector for side light housing.
3. Reverse procedure for installation.
Oven Cycle/Clean and Surface Power On
Indicator Light Removal
Condition Requirements:
Control Panel Assembly Removed
1. Hold the red lens and slide off the indicator light. The
indicator light will only slide in one direction.
2. Disconnect two connectors from the indicator light.
3. Reverse procedure for installation.
©2009 Viking Preferred Service