MAINTENANCE
188
Headlight - Adjustment
Vertical Adjustment
Note
Check and correct the tire pressures
prior to adjusting the headlight.
The vertical beams of the left hand
and right hand headlights can only
be
adjusted
adjustment is not possible.
The headlight adjuster bracket is located
under the front subframe.
Switch the headlight dipped beam
▼
on.
Loosen
▼
the
headlight
front
subframe
allow restricted movement of the
headlight.
Using the mark on the bracket,
▼
adjust the position of the headlight
to give the required beam setting.
Each mark on the front subframe is
equal to 1° movement.
3
2
IASM00153
1.
Fastener
2.
Front subframe alignment marks
3.
Front subframe
4.
Adjustment bracket
together.
Independent
the
fastener
securing
bracket
to
sufficiently
1
Tighten
▼
fasteners to 9 lbf ft (9 lbf ft (12 Nm).
Recheck
▼
settings.
Switch the headlight dipped beam
▼
off.
Headlight Replacement
The
headlight
maintenance
headlight unit must be replaced in the
event of the failure of the headlight.
the
to
4
the
headlight
bracket
the
headlight
unit
is
a
free
LED
unit.
beam
sealed,
The