Triumph Street Triple R Owner's Handbook Manual page 121

Caution
Do not let the
long periods as this may lead to
overheating which will cause damage
to the engine.
SERVICE
1
2
21.5 C
o
N
2
4
6
8
10
12
14
F E
3
1. RUN position on the engine start/stop
switch (Street Triple R shown)
2. START position on the engine start/stop
switch (Street Triple R shown)
3. Neutral indicator (Street Triple RS and
Street Triple Moto2™ Edition)
4. Neutral indicator (Street Triple R)
5. ON position on the ignition switch
To start the engine:
Check that the stop switch is in the
▼
RUN position.
Make sure the transmission is in
▼
neutral.
Pull the clutch lever fully into the
▼
handlebar.
Turn the ignition switch to the ON
▼
position.
HOW TO RIDE THE MOTORCYCLE
Continued
engine idle for
P
0
4 5
Note
When the ignition is switched on, the
tachometer will quickly sweep from zero
to maximum and then return to zero
(Street Triple R only). The instrument
warning lights will
will then go off (except those which
normally remain on until the engine
starts - see page 69 for Street Triple RS,
Street Triple Moto2™ Edition and page 41
for Street Triple R.
It is not necessary to wait for the
tachometer to return to zero before
starting the engine
only).
A transponder is installed within the
key to turn off the engine immobilizer.
To make sure the immobilizer functions
correctly, always have only one of the
ignition keys near the ignition switch.
Having two ignition keys near the
switch may interrupt the signal between
the transponder
immobilizer. In this situation the engine
immobilizer will remain active until one
of the ignition keys is removed.
Leaving the throttle fully closed,
▼
push the starter button until the
engine starts.
Slowly release the clutch lever.
▼
illuminate and
(Street Triple R
and the engine
121