Triumph Street Triple R Owner's Handbook Manual page 36

GENERAL INFORMATION
36
To disable the turn signal self-cancel
system refer to the Bike Setup section
on page 78.
To manually turn off the turn signal,
press and release the turn signal switch
in the central position.
Note
If the motorcycle stops for any reason,
the signals will flash for the remainder
of the time
manually canceled by the rider.
Heated Grips Switch (if equipped)
The heated grips will only heat when
the engine is running.
When the heated grips are switched on,
the heated grips symbol will appear in
the display and the selected heat level
will be shown.
There are three levels of heat: low,
medium and high. This is indicated by
the different colors of the symbols
shown in the display.
1
1. Low heat symbol (yellow)
2. Medium heat symbol (orange)
3. High heat symbol (red)
For maximum benefit in cold conditions,
from the OFF position press the switch
once for the high heat setting initially
and then reduce the heat level by
pressing the switch again for a low heat
setting when the grips have warmed up.
To turn off the heated grips, press and
release the switch until the heated
grips symbol is no longer shown in the
display.
and distance unless
2 3
Low Power Voltage Cut Off
If a low voltage is detected, the heated
grips switch will power off. The heated
grips will not function again until the
voltage rises to a safe level.
The switch will not power back on
automatically even if the voltage rises to
the safe level. The user must manually
press the switch again to activate the
heated grips.
High Beam Button
If the Daytime Running Light (DRL)
switch is in the dip beam position, when
the high beam button is operated then
the high beam will be switched on. Each
press of the button will swap between
dip and high beam.
If the DRL switch is in the daytime
running lights position, then press and
hold the high beam button to turn the
high beam on. It will remain on as long
as the button is held in and will turn off
as soon as the button is released.