Triumph Street Triple R Owner's Handbook Manual page 42

GENERAL INFORMATION
42
Immobilizer/Alarm Indicator Light
This Triumph motorcycle is equipped
with an engine immobilizer which is
activated when the ignition switch is
turned to the OFF position.
Not Equipped With Alarm
When the ignition switch is turned to
the OFF position, the immobilizer light
will flash on and off for 24 hours to
show that the engine immobilizer is on.
When the ignition switch is turned to
the ON position the immobilizer and the
indicator light will be off.
If the indicator light remains on it
indicates that the immobilizer has a
malfunction that requires investigation.
Contact an authorized Triumph dealer
as soon as possible to have the fault
checked and rectified.
Equipped With Alarm
The immobilizer/alarm
only illuminate when the conditions
described in
accessory alarm instructions are met.
Anti-lock Braking System (ABS)
Warning Light
When the ignition switch is
turned to the ON position, it is
normal that the ABS warning
light will flash on and off. The light will
continue to flash after engine start-up
until the motorcycle first reaches a
speed exceeding 6 mph (10 km/h) when
it will go off.
Note
Traction control will not function if
there is a malfunction with the ABS.
The warning lights for the ABS, traction
control and the MIL will be illuminated.
light
the genuine Triumph
The warning light should not illuminate
again until the engine is restarted
unless there is a fault.
If the warning light becomes illuminated
at any time while riding it indicates that
the ABS has a malfunction that requires
investigation.
If the ABS is not functioning, the brake
system will continue to function as a
non-ABS equipped brake system.
Do not continue to ride for longer than
is necessary with the warning light
illuminated.
Contact an authorized Triumph dealer
as soon as possible to have the fault
checked and rectified. In this situation
braking too hard will cause the wheels
to lock resulting in loss of motorcycle
control and an accident.
will
Traction Control (TC) Indicator Light
The
indicator light is used to
indicate
control system is active and is
working to limit rear wheel slip during
periods of hard acceleration or under
wet or slippery road conditions. Traction
control will not function if there is a
malfunction with the ABS. The warning
lights for the ABS, traction control and
the MIL will be illuminated.
Warning
Traction Control
that the traction
(TC)