Triumph Street Triple R Owner's Handbook Manual page 34

Hide thumbs Also See for Street Triple R:
Table of Contents

Advertisement

GENERAL INFORMATION
34
Horn Button
When the horn button is pushed, with
the ignition switch turned on, the horn
will sound.
High Beam Button
When the high beam button is pressed
the high beam will be switched on. Each
press of the button will swap between
dip and high beam.
The headlight will function when the
ignition switch is turned to the ON
position. The headlight will go off while
pressing the starter button until the
engine starts.
A lighting on/off switch is not installed
on this model. The position light, brake/
tail light and license plate light all
function automatically when the ignition
is turned to the ON position.
A Pass feature is not available on this
model.
Heated Grips Switch (if equipped)
The heated grips will only heat when
the engine is running.
When the heated grips are switched on,
the heated grips symbol will appear in
the display and the selected heat level
will be shown.
There are three levels of heat: low,
medium and high. This is indicated by
the different colors of the symbols
shown in the display.
1
1.
Low heat symbol (yellow)
2.
Medium heat symbol (orange)
3.
High heat symbol (red)
2
3
For maximum benefit in cold conditions,
from the OFF position press the switch
once for the high heat setting initially
and then reduce the heat level by
pressing the switch again for a low heat
setting when the grips have warmed up.
To turn off the heated grips, press and
release the switch until the heated
grips symbol is no longer shown in the
display.
Low Power Voltage Cut Off
If a low voltage is detected, the heated
grips switch will power off. The heated
grips will not function again until the
voltage rises to a safe level.
The switch will not power back on
automatically even if the voltage rises to
the safe level. The user must manually
press the switch again to activate the
heated grips.
Street Triple RS and
Street Triple Moto2™ Edition
8
6
7
5
1.
Cruise control adjust switch (if equipped)
2.
Dipped beam/Daytime Running Lights
(DRL) switch (if equipped)
3.
MODE button
4.
Joystick
5.
Horn button
6.
Turn signal switch
7.
Heated grips switch (if equipped)
8.
High beam button
1
2
3
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Street triple rsStreet triple moto2 edition

Table of Contents