Table of Contents
Advertisement
Service Mode > NETWORK GR.
■ PFW SETTING
Service Mode > NETWORK GR. > PFW SETTING
IPTBROAD
Detail
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
SP.ADMIN.MODE
Service Mode > SP.ADMIN.MODE
MAINTENANCE C.
NANDROM-ERR-CLR
Detail
Adj/Set/Operate Method
Setting to allow transmission of multicasts
To set the behavior concerning multicast address transmissions.
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
Transmission to IPv4 multicast address, broadcast address and subnet broadcast address is
allowed even if the default policy is set to "Reject" in the IPv4 transmission setting.
In addition, IPv6 multicast address transmission is allowed even if the default policy is set to
"Reject" in the IPv6 transmission setting. To also reject multicast transmission, the setting can be
changed by switching the service mode value.
0/1
0: Allow multicast transmission
1: Reject multicast address transmission when the transmission default policy is set to "Reject"
0
Not in use
E602-0008 error code clear
To clear E602-0008 (depletion of NANDROM blocks) when it occurred.
Enter setting value, and then press OK key.
232
9. Service Mode
Advertisement
Table of Contents
Troubleshooting
