Canon imageCLASS LBP325dn Service Manual page 241

Service Mode > NETWORK GR.
Service Mode > NETWORK GR. > IPSEC SETTING
IKEINTVL
Detail
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
SPDALDEL
Detail
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
IPSDEBLV
Detail
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Setting of IKE retry interval
To set the IKE retry interval (sec.).
1) Enter setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
1 to 30
Second
5
ON/OFF of initialization at next startup
To set whether to initialize policies at next startup.
Setting this value to "1" deletes all the registered policies at the next startup to initialize policies.
The device refers to this setting value every time it starts up and processes initialization if set to
"1." Return this value to "0" after initialization is complete. Use this item in emergency case where
policies are inconsistent.
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
Be sure to return this value to"0" after initialization is complete.
0/1
0: Not initialize
1: Initialize
0
Level setting for IPsec logs
To set the debug level for IPsec.
1) Select the item, and then press OK key.
2) Turn OFF/ON the main power switch.
Since IPsec operates by a different process from the main program, log information is not kept in
the Sublog Board.
Therefore, change the value when obtaining the IPsec log.
The setting is enabled after restart, and this value becomes"0" internally after restart.
When this log is enabled, a file named "/APL_LOG/ipsec/ipseclog.txt" is generated, in which the
log information is stored. However, this file is cleared when the power is turned ON and then OFF.
0 to 10
0: Not keep logs
1 to 3: Log level 1 to 3, fatal error info
4 to 6: Log level 4 to 6, warning info
7: Log level 7, important log info
8 to 10: Log level 8, all logs
0
231
9. Service Mode