Safety Decals - MQ Power WHISPERWATT DCA25SSIU4FC8 Operation Manual

Safety decals are attached to the generator as shown in
Figure 1. Keep these safety decals clean at all times. When
the safety decals become worn or damaged, contact your
nearest dealer or the Multiquip Parts Department.
This machine stops and starts automatically
and without notice.
WARNING
HOT COOLANT can cause
severe burns.
Do not remove cap if
radiator is hot.
DANGER
Using a generator indoors CAN KILL YOU IN MINUTES.
Generator exhaust contains carbon monoxide. This is
a poison gas you cannot see or smell.
GAC-2.2H Honda Engines POWERED by 120V 15A V 120 LA CARCASSE DU MOTEUR NEUTRE MIS A LA MASSE A NEUTRAL BONDED TO FRAME
211052 GR PRISE DE TERRE AC CIRCUIT BREAKER INTERRUPTEUR DE COURANT PRINCIPAL
GAC-2.2H POWERED by Honda Engines 120V 15A V NEUTRAL BONDED TO FRAME NEUTRE MIS A LA MASSE A LA CARCASSE DU MOTEUR 120 GAC-2.2H Honda Engines POWERED by 120V 15A 120 V LA CARCASSE DU MOTEUR NEUTRE MIS A LA MASSE A NEUTRAL BONDED TO FRAME
TERRE GR PRISE DE 211052 AC CIRCUIT BREAKER INTERRUPTEUR DE COURANT PRINCIPAL GR PRISE DE TERRE 211052 INTERRUPTEUR DE AC CIRCUIT BREAKER COURANT PRINCIPAL
ONLY use OUTSIDE and
NEVER use inside a home
far away from windows,
or garage. Even if doors
doors, and vents.
and windows are open.
Avoid other generator hazards.
READ MANUAL BEFORE USE.
Operation of this equipment may create
sparks that can start fires around dry
vegetation.
A spark arrestor may be required.
The operator should contact local fire
agencies for laws or regulations
relating to fire prevention requirements.
WARNING
ENVIRONMENTAL
This unit is designed to contain operating uids only.
The environmental containment is not designed to
control uids from an external source. It is the operator's
responsibility to monitor uid levels at all times.
DO NOT EXCEED THE RECOMMENDED
MAXIMUM CAPACITY
P/N M91110000
WARNING
ELECTRIC SHOCK HAZARD
Do not touch internal wiring
or connections while this
machine is operating.
Turn power off before
servicing.
M92010000
WARNING
ARC FLASH AND SHOCK HAZARD
Appropriate PPE Required
Appropriate Personal Protection
CONTROL AND OPERATION PANEL
Equipment and Tools Required
when working on this equipment.
M92010070
PAGE 4 — DCA25SSIU4FC8 60 HZ GENERATOR • OPERATION MANUAL — REV. #0 (08/23/22)
CAUTION
M92010060
CAUTION
Maximum capacity of lifting
bail is 6,620 lb.
M90310000
TOP VIEW
FRONT VIEW
M90320010
M90420000
25 50 75 180 12 18
140 220 24
PSI °F Volts
0 100 100 260 6 30
Oil Press. Water Temp Battery
ECU R
Intergrated Gauge Control
Low Oil Pressre
½ 150
High temp. 120 180
60
Over Crank °F RPM x 10
E F 0 210
Over Speed
Engine Started
Fuel Speed
Figure 1. Safety Decals
NOTICE
For safety decal part numbers, refer to the associated
parts manual.
M15000140
CAUTION
Ensure the "Auto-Off/Reset-Manual" switch is
in the "Off/Reset" position. If it is not, when
the battery cables are connected, the engine
will crank and attempt to start.
M91010040
CAUTION
HOT PARTS can burn skin.
DO NOT touch until the
machine has sufficiently
cooled.
M91010000
CAUTION
Stop engine before
switching.
CONTROL BOX
(RIGHT SIDE)

SAFETY DECALS

WARNING
ENGINE EXHAUST can cause
MOVING PARTS can cause
severe injury or death.
severe injury.
DO NOT operate with doors
Use only in open, well
open.
ventilated areas or
Stop engine before servicing. vent exhaust outside.
M90300000
SIDE VIEW
CAUTION
This machine stops and starts automatically
and without notice.
WARNING
DANGER
MOVING PARTS can cause
severe injury.
DO NOT operate with doors
HIGH VOLTAGE
open.
Stop engine before servicing.
M90300000
SIDE VIEW
WARNING WARNING
ELECTRIC SHOCK HAZARD ELECTRIC SHOCK HAZARD
Before connecting this generator to any building's
Do not touch output Always complete the grounding
electrical system, a licensed electrician must install
terminals while this path from the ground terminal
an isolation (transfer) switch.
machine is operating. on the genset to an external
grounding source.
Turn power off before
Serious injury or death may result without this
servicing.
See instruction manual for
transfer switch.
details.
M92100020A
WARNING
ELECTRIC SHOCK HAZARD
OUTPUT TERMINAL
Do not touch internal wiring
or connections while this
PANEL COVER
machine is operating.
Turn power off before
servicing.
M92010000
WARNING
M90320000
M92010060
M92010040
WARNING
M92010050