Setting The Separator Feed Gap - Pitney Bowes AddressRight DA Series Operator's Manual

1. Setting the Separator Feed Gap

Whenever you switch from one material type to another, you need to
set the gap between the separator assemblies and the feed rollers
before printing begins.
A. Unlatch and lift the lock
levers to their highest
position. This raises the
separator assemblies and
locks them in place.
B. Place a sample piece of material
between the separator tips (the lower
section of the separator assemblies)
and the feed rollers.
NOTE: In this example only one
separator assembly is needed
because of the width of the media
being used. For better performance
raise the unused separator assembly
and lock in place.
C. Move the lock lever to the central
position so that the separator assembly
drops onto the material, then push
the lever down to lock the separator
assembly in place.
Tips for Setting the Proper Separator Feed Gap
A. Postcards - Try setting a slightly larger gap by adding one sheet
of standard paper to one of the postcards then setting the gap.
SV61722 Rev. D
Printer Basics • 2
Lock Lever raised
to highest position
for setting gap.
Lock Lever down
in locked position
for running job.
Separator Tips
Feed Rollers
2-5