Print Head Home Position - Pitney Bowes DA50S Service Manual

6 • Adjustments
DA70S/DA75S (WS71/WS76) Adjustments
6.14 Print Head
Home Position
6-12
In order for the Service Station to properly position and seal the Print Heads,
the Print Head home position and the Service Station must be in proper
alignment. The finger on the Service Station locks with the protruding tip on
the bottom of the Print Head Holder to press seal the Service Station wipers
against the Print Heads to prevent drying and clogging of the ink jets.
The alignment must be such that during movement of the Service Station
Sled, its finger does not miss, and locks with, the protruding tip on the Print
Head Holder.
Realignment will be necessary if the Service Station or the Print Head Holder
is removed, or if over a period of time the set screw becomes loose, altering
the Print Head home position.
The Print Head home position screw is located on the U-Channel's rear
plate. (Remove the rear cover for access.)
Print Head Home
Position Set Screw
Figure 6-13 DA70S/DA75S Print Head Home Position Set Screw
SV61831 Rev. A DA50S/DA55S/DA70S/DA75S AddressRight™ Printers Service Manual