Panasonic WV-CU650 Operating Instructions Manual page 77

6. Select a desired preset position number by performing
either of the following.
• Rotate the JogDial clockwise or counterclockwise.
• Press the + or – button.
Cam Posi Map
Cam-P016 C005 Pre032
Note: You can select a preset position number from 1
to 256.
7. Press the ENTER or CAM (SET) button.
"Set OK?" will appear on the LCD.
Cam Posi Map
Cam-P016 Set OK?
Note: To cancel the setting, press the EXIT or MON
(ESC) button. The LCD display will return to Step 6.
8. Press the ENTER or CAM (SET) button again.
The specified camera channel and preset position num-
ber will be set for the selected camera position.
"Memory" will appear on the LCD for a few seconds,
and the LCD display will return to Step 1.
Cam Posi Map
Cam-P016 Memory
To delete a camera position
1. Select a camera position to delete by performing either
of the following.
• Rotate the JogDial clockwise or counterclockwise.
• Press the + or – button.
Cam Posi Map
Cam-P016 C005 Pre032
2. Press the CLEAR button.
"Clear OK?" will appear on the LCD.
Cam Posi Map
Cam-P016
Note: To cancel deleting the camera position, press the
EXIT or MON (ESC) button.
3. Press the ENTER or CAM (SET) button.
The camera position will be deleted.
"Erased" will appear on the LCD for a few seconds, and
the LCD display will return to Step 1.
407
407
407
407
407
Clear OK?
Cam Posi Map
Cam-P016
G Associating Camera Numbers with
Unit Numbers
You can register camera-unit maps (the association of cam-
era numbers and unit numbers). Up to 999 camera unit
maps can be registered. You can select a camera by enter-
ing the camera channel alone, even if the camera is con-
nected to system unit not currently selected.
Note: If "Enable" is selected in Step 2, you can select only
camera numbers associated with unit numbers.
1. Display "Cam-Unit Map" sub menu. (Refer to Step 1 to
4 of p. 61 To Recall Menu Functions.)
Cam-Unit Map
Disable
Note: To disable camera-unit maps, display the "s"
mark beside "Disable" by rotating the shuttle ring
counterclockwise or moving the 3D joystick to the
left.
Cam-Unit Map
Disable
2. Press the ENTER or CAM (SET) button.
The camera-unit setting will appear on the LCD.
Cam-Unit Map
Cam001
3. Select a desired camera channel by performing one of
the following.
• Rotate the JogDial clockwise or counterclockwise.
• Press the + or – button.
• Enter the camera number with the numeric buttons.
Cam-Unit Map
Cam016
Notes:
• To register a new position number, press the
numeric buttons.
• You can select a camera channel from 1 to 999.
• The following are the factory default settings.
407
Erased
408
Enable
408
Enable
408
Unit01
408
Unit01
77