Panasonic WV-CU650 Operating Instructions Manual page 17

G Messages Displayed on the LCD
Invalid
Invalid
This message is displayed in the following circumstances.
• When you have entered a wrong user ID or password,
etc.
• When you have entered a camera number or menu
number, etc. that is not existing.
Busy
• When a selected monitor is controlled by a higher-level
user, the monitor number and "Busy" blinks on the LCD.
(You cannot control the monitor.)
• When a selected camera is controlled by a higher-level
user, the camera number and "Busy" blinks on the
LCD. (You cannot control the camera.)
• To cancel the Busy status, select another monitor, or
wait until "Busy" goes out.
Mon02 Cam016
Busy
"Busy" status is activated for a monitor.
Mon02 Cam016
Busy
"Busy" status is activated for a camera.
HD316
HD316
Prohibited
Mon02 Cam016
• When you have tried an operation not authorized by the
function level setting, camera level setting, or selected
system unit, "Prohibited" blinks on the LCD.
• When you have forgotten to select a system unit or
monitor before selecting a camera, "Prohibited" blinks
on the LCD.
• When you have selected a system unit disconnected
from the system, "Prohibited" blinks on the LCD.
• After a few seconds, the LCD display will return to the
default status.
Notes:
• After a few seconds, this message will automatically
disappear.
• The illustration is an example in which a camera num-
ber other than 1 to 256 has been entered.
• In this document, gray area on illustration shows blink-
ing.
Controller No.1 No Exist Error
Controller No.1
No Exist Error
This message is displayed when no system controller is set
to CONTROLLER NO.1. Check that a system controller is
set to CONTROLLER NO. 1 (Refer to p. 25 CONTROLLER
NO. Switch Setting.)
HD316
Prohibited
17