Panasonic WV-CU650 Operating Instructions Manual page 76

Camera Table3
Cam064
Note: You can select a camera channel from 1 to 999.
5. Rotate the shuttle ring clockwise or move the 3D joy-
stick to the right. The cursor will jump to the next item.
Camera Table3
Cam064
Note: To return to Step 4, rotate the shuttle ring coun-
terclockwise or move the 3D joystick to the left.
6. Select E (= Enabled) or D (= Disabled) by performing
either of the following.
• Rotate the JogDial clockwise or counterclockwise.
• Press the + or – button.
Camera Table3
Cam064
E (= Enabled): The operator can display the cam-
era image on the monitor and control panning/tilt-
ing. (VIEW & CONTROL)
D (= Disabled): The operator can display the cam-
era image on the monitor, but cannot control the
panning/tilting. (VIEW ONLY)
Note: To change the settings of other cameras, repeat
Step 4 to 6.
7. Press the ENTER or CAM (SET) button.
"Set OK?" will appear on the LCD.
Camera Table3
Note: To cancel the setting, press the EXIT or MON
(ESC) button. The LCD display will return to Step 6.
8. Press the ENTER or CAM (SET) button again.
The camera levels will be set for the selected table.
"Memory" will appear on the LCD for a few seconds,
and the LCD display will return to Step 1.
Camera Table3
76
406
=E
406
=E
406
=D
406
Set OK?
406
Memory
G Camera Position Registration or
Clearing
This system controller can memorize camera position num-
bers, which are the combination of camera numbers and
preset position numbers. By entering a camera position
number, you can select a desired camera and preset posi-
tion at a time. You can register up to 1 000 camera position
numbers.
1. Display "Cam Posi Map" sub menu. (Refer to Step 1 to
4 of p. 61 To Recall Menu Functions.)
Cam Posi Map
Cam-P001 C001 Pre001
2. Select a camera position number to register by per-
forming one of the following.
• Rotate the JogDial clockwise or counterclockwise.
• Press the + or – button.
• Enter the camera position number with the numeric
buttons.
Cam Posi Map
Cam-P016 C001 Pre016
Notes:
• To register a new position number, press the
numeric buttons.
• You can select a camera position number from 0 to
999.
3. Rotate the shuttle ring clockwise or move the 3D joy-
stick to the right. The cursor will jump to the next item.
Note: To return to Step 2, rotate the shuttle ring coun-
terclockwise or move the 3D joystick to the left.
4. Select a desired camera channel by performing one of
the following.
• Rotate the JogDial clockwise or counterclockwise.
• Press the + or – button.
• Enter the camera number with the numeric buttons.
Cam Posi Map
Cam-P016 C005 Pre016
Note: You can select a camera channel from 1 to 999.
5. Rotate the shuttle ring clockwise or move the 3D joy-
stick to the right. The cursor will jump to the next item.
Note: To return to Step 4, rotate the shuttle ring coun-
terclockwise or move the 3D joystick to the left.
407
407
407