Panasonic WV-CU650 Operating Instructions Manual page 69

3. Perform the camera setting while watching the setup
menu on the monitor.
Available controls and functions
<Main unit>
Shuttle ring clockwise: Moves to the next page.
Shuttle ring counterclockwise: Moves to the previous
page.
JogDial clockwise or counterclockwise: Changes the
selected parameter.
+ button: Increases a numeric value.
– button: Decreases a numeric value.
Numeric buttons: Enters a numeric parameter.
CLEAR button (WJ-HD300 Series Only): Clears an
entry such as a password.
Button 0 (WJ-HD300 Series Only): If you enter only "0"
for a parameter, the parameter will be cleared.
CAM (SET) button: Determines the selected parameter
and moves to the sub menu.
MON (ESC) or EXIT button: Returns to the upper
menu.
<Joystick unit>
3D joystick upward (L): Moves the cursor up.
3D joystick downward (M): Moves the cursor down.
3D joystick leftward (t): Moves the cursor to the left.
3D joystick rightward (s): Moves the cursor to the
right.
Zoom wheel controller to the right: Moves to the next
page.
Zoom wheel controller to the left: Moves to the previ-
ous page.
Top button: Determines the selected parameter and
moves to the sub menu.
4. Press the F2 button.
The setup menu of selected system unit will be closed,
and "s" mark will light up beside "Off".
G On-screen Display (OSD) Control
1. Display "Switcher OSD" sub menu. (Refer to Step 1 to 4
of p. 61 To Recall Menu Functions.)
Switcher OSD
Clock Cam Event Mon
F1 F2
2. Press one of the F1 to F4 buttons.
One of the following OSD items will appear/disappear
on/from the active monitor.
Available buttons and functions
F1: Clock
Displays/hides the time and date.
302
F3 F4
F2: Camera title
Displays/hides the camera title.
F3: Event
Displays/hides the event.
F4: Monitor status
Displays/hides the monitor status.
G Video Loss History Table
1. Display "VLD History" sub menu. (Refer to Step 1 to 4 of
p. 61 To Recall Menu Functions.)
VLD History
On Off
F1 F2
2. Press the F1 button.
The VIDEO LOSS HISTORY table will appear on the
active monitor.
3. To close the VIDEO LOSS HISTORY table, press the F2
button.
G VCR/Camera Selection
(WJ-FS416, etc: Available Only for
Switchers Installing Multiplexer
Board)
If a Multiplexer board is installed inside the switcher, you
can activate either VCR playback or camera picture display
on an active monitor.
1. Display "Mux VCR/CAM" sub menu. (Refer to Step 1 to
4 of p. 61 To Recall Menu Functions.)
Mux VCR/CAM
VCR CAM
F1 F2
Note: "s" mark will light up beside the activated set-
ting.
2. Press the F1 or F2 button.
The monitor display will be changed between playback
pictures and live images, and "s" mark will light up
beside the activated setting.
Mux VCR/CAM
VCR CAM
F1 F2
303
F3 F4
304
F3 F4
304
F3 F4
69