Panasonic WV-CU650 Operating Instructions Manual page 39

4. Enter the ID number by pressing the numeric buttons.
The user ID entered will appear on the LCD.
User ID
Notes:
• To delete a character, press the CLEAR button.
• You can also enter your user ID without pressing
the CAM (SET) button.
5. Press the CAM (SET) button. When the ID number is
correct, "Password" entry form appears on the LCD.
User ID
Password
6. Enter the password by pressing the numeric buttons.
Then, press the CAM (SET) button.
User ID
Password
Notes:
• To delete a character, press the CLEAR button.
• The password entered will be displayed as "∗"
marks.
7. When the password is correct, "Login OK" appears on
the LCD. Then, the LCD changes to the operation dis-
play.
Login OK
Mon04 Cam128
F1 F2
Mon04 Cam128
F1 F2
__650
650
_____
650
__∗ ∗ ∗
Unit16
F3 F4
HD316
F3 F4
Notes:
• The smallest monitor, camera, and unit numbers are
displayed on the LCD.
• Three seconds after the unit number was deter-
mined, model number appears in place of unit num-
ber.
• When the ID or password is wrong, "Invalid" blinks
on the LCD. Then, the LCD returns to the login
standby display.
Invalid
PS Data Mode
•
No User
• When a system controller cannot communicate
properly with a system unit, the LCD display after
login becomes as follows.
Mon-- Cam---
Unit Error
In this case, check the connection and settings
between the system controller and system unit.
(Refer to p. 20.)
Unit01
39