I Controller Functions - Panasonic WV-CU650 Operating Instructions Manual

Available buttons and functions
F1: VCR
Activates VCR playback.
F2: CAM
Activates camera picture display.
Note: If the Multiplexer board is receiving no video
input signal, "s" mark will light up beside VCR.
G Still Mode
(WJ-FS416, etc: Available Only for
Switchers Installing Multiplexer
Board)
If a Multiplexer board is installed inside the switcher, you
can change the multiscreen monitor display from the mov-
ing mode to the still mode.
1. Display "Mux Still" sub menu. (Refer to Step 1 to 4 of p.
61 To Recall Menu Functions.)
Mux Still
"Input Still CH"
2. Select the camera channel you wish to change to the
still mode by performing either of the following.
• Press the + or – button.
• Enter the camera number with the numeric buttons.
The entered number will appear on the LCD.
Mux Still
"Enter F1 Button"
Notes:
• To cancel the numeric entry, press the CLEAR but-
ton.
• To activate the still mode for all camera channels or
spot monitor display, skip this step or enter "0".
Mux Still
"Enter F1 Button"
70
305
____9
____0
3. Press the F1 button.
• The still mode will be activated for the selected
camera channel.
• The specified camera channel will blink on the LCD
for a few seconds, and the LCD display will return
to Step 1.
Mux Still
Still CH=__9
Mux Still
Still CH=All
Note: To return the multiscreen monitor display from the
still mode to moving mode, perform 1 to 3 again.

I Controller Functions

G Camera Cleaning
1. Display "Camera Cleaning" sub menu. (Refer to Step 1
to 4 of p. 61 To Recall Menu Functions.)
Camera Cleaning
Start Cancel 001-999
F1 F2
2. Select the camera to clean first by performing one of
the following.
• Rotate the JogDial clockwise or counterclockwise.
• Press the + or – button.
• Enter the camera number with the numeric buttons.
Camera Cleaning
Start Cancel 003-999
F1 F2
3. Rotate the shuttle ring clockwise or move the 3D joy-
stick to the right. The cursor will jump to the next item.
4. Select the camera to clean last by performing one of
the following.
• Rotate the JogDial clockwise or counterclockwise.
• Press the + or – button.
• Enter the camera number with the numeric buttons.
305
305
401
F3 F4
401
F3 F4