Nautilus Schwinn 800IC Service Manual page 96

17. Attach the second string to the Power Input Connection.
NOTICE: Do not crimp the Cable.
18. Gently pull the old Wiring Harness from the Frame Assembly while
guiding the Speed Sensor and Power Input Connection into the Frame
Assembly. Continue pulling until the strings are fully routed through the
Frame Assembly, and stop pulling when both ends of each string are
exposed.
Note: If the Wiring Harness becomes hard to pull or snagged at any
point, briefly pull the strings in the opposite direction to release them.
19. Holding the new Wiring Harness next to the old one, remove
the string from the old Speed Sensor Connection and attach it to the
new Speed Sensor Connection. Be sure that it is the Speed Sensor
Connection and not the other Connections.
20. Remove the string from the end of the old Power Input
Connection, and attach it to the new Power Input Connection.
21. Route the new Wiring Harness through the Frame Assembly by
gently pulling the strings one at a time, being sure to alternate between
the strings every couple of inches of routing.
NOTICE: Do not crimp the Cables.
22. With the new Wiring Harness fully routed, remove the strings.
Connect the Speed Sensor Cable.
NOTICE: Do not crimp the Cable.
96