Nautilus Schwinn 800IC Service Manual page 35

10. Apply Loctite
242 (or equivalent) to the Pedal threads.
®
11. To reinstall a Pedal, start the Pedal by hand. If you feel resistance
and the Pedal does not turn smoothly into the Crank Arm, make sure
that the threads are aligned correctly. Be sure that the Pedal is going on
straight into the Crank Arm. If the Pedal is not in-line with the opening,
remove the Pedal and start again.
Note: The Left Pedal is reverse-threaded. Orientation is based
from a seated position on the bike. The Left Pedal has an
"L", the Right Pedal an "R".
12. With the Pedal started by several hand turns into the Crank Arm, fully
tighten it with the Pedal Wrench.
13. Confirm that the Pedal is fully tightened with the Pedal Wrench.
14. Repeat with the other Pedal.
Note: Be sure to check the Pedals weekly to confirm that they are
fully tightened.
Since this machine operates with a fixed gear, do not back,
or reverse, pedal. Doing so may loosen the Pedals, which
could result in damage to the machine and/or injury to the
user. Never operate this machine with loose Pedals.
15. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
35