Nautilus Schwinn 800IC Service Manual page 73

R
4. Start the Pedal by hand. If you feel resistance and the Pedal
does not turn smoothly into the Crank Arm, make sure that the
threads are aligned correctly. Be sure that the Pedal is going on
straight into the Crank Arm. If the Pedal is not in-line with the
opening, remove the Pedal and start again.
5.
With the Pedal started by several hand turns into the Crank Arm, fully
tighten it with the Pedal Wrench.
6. Confi rm that the Pedal is fully tightened with
the Pedal Wrench.
7. Repeat with the other Pedal.
Note: Be sure to check the Pedals weekly to
confi rm that they are fully tightened.
Since this machine operates with a fi xed gear, do not back, or reverse, pedal. Doing so may loosen the Pedals, which could
result in damage to the machine and/or injury to the user. Never operate this machine with loose Pedals.
8. Final Inspection
Inspect your machine to ensure that all hardware is tight and components are properly assembled.
Do not use until the machine has been fully assembled and inspected for correct performance in accordance with the Owner's
Manual.
L
73