Nautilus Schwinn 800IC Service Manual page 89

24. Put the Drive Belt around the edge of the Drive Pulley. Slowly turn
the Drive Pulley and carefully walk the Drive Belt onto the Drive Pulley.
Make sure the Drive Belt is aligned on the Flywheel Pulley and Drive
Pulley.
Be sure to keep fingers clear of all pinch hazards as
you turn the Drive Pulley and Flywheel.
25. Connect the wire connector from the new Speed Sensor Cable to the
harness plug, and push the connection into the Left Frame Upright.
26. Reinstall the Lower Rubber Grommet in the lower opening in the Left
Frame Upright to hold the Speed Sensor Cable in position.
NOTICE: Do not crimp the cable.
27. Re-install all remaining parts that were removed in reverse order up
to the Crank Nut.
NOTICE: Do not crimp any cables. Install the Flywheel Tensioners
at the position that you recorded in step 15. Make sure
the Flywheel can turn easily. Verify that the Speed
Sensor and Speed Sensor Magnet on the Flywheel do
not touch.
Drive Pulley
Lower Rubber
Grommet
Left Frame Upright
Speed Sensor
Speed Sensor
Magnet
89
Drive Belt
Speed Sensor Cable
Speed Sensor