Nautilus Schwinn 800IC Service Manual page 93

7. Remove the Resistance Cable from the Brake Assembly.
Note: If present, remove any adhesive used to secure the Cable.
8.
Using a pair of clippers or scissors, cut the Zip-Tie that secures
the Resistance Cable to the Frame Assembly.
Note: Be sure not to cut the Cable.
9.
Remove the Resistance Cable Grommet from the Frame
Assembly that captures the Resistance Cable.
Note: The Resistance Cable Grommet is needed for shipment of the
machine only. The Grommet does not need to be re-installed and can
be discarded.
10. Remove the Speed Sensor Grommet from the Frame Assembly
that captures the Speed Sensor Cable.
11. Gently pull the Speed Sensor Cable from the Frame Assembly just
enough to locate the Speed Sensor Connectors, and disconnect them.
Speed Sensor
Assembly
Zip-Tie and Resistance Cable
Grommet
Resistance Cable
93
Brake Assembly
Speed Sensor
Grommet
Speed Sensor
Cable