Table of Contents
Advertisement
5.
Repeat the last three steps on the left side of the bike.
6.
Using a #2 Phillips screwdriver, remove the indicated hardware from
the Drive Belt Cover. Carefully remove the Drive Belt Cover and set it
safely aside for reassembly.
Note: The oval indicates the two machine screws with washers.
7.
Record the number of threads showing on the Tensioner Eyebolt on
each side of the Tensioner Support Bracket.
8.
Using a 10mm wrench, loosen the outer Flywheel Retainer Nut on
both sides of the machine. Loosen the outer Flywheel Retainer Nut until
there is a visible slack in the Drive Belt. This will ease the removal of the
Drive Belt from the Drive (Crank) Pulley.
Drive Belt Cover
Note: Please disregard the Right Crank Arm in the above
image. It was removed during an earlier step.
Flywheel Bracket
48
Tensioner Eyebolt
Outer
Flywheel
Retainer
Nut
Hide quick links:
Advertisement
Table of Contents
