Table of Contents
Advertisement
5.
Using a 15mm wrench, turn the inner portion (CP3) of the Crank
Puller clockwise. The Crank Arm will slide off as it is tightened.
6. Using a #2 Phillips screwdriver, loosen and remove the hardware that
attaches the Fender to the Main Frame. Set the hardware safely aside for
reassembly.
NOTICE: Hold the Fender so that it does not fall.
7. Loosen the Resistance Knob to the minimum resistance setting.
8.
Using a #2 Phillips screwdriver, remove the hardware (indicated by
ovals) that secures the Resistance Sensor. Allow the Resistance Sensor
to hang from the Cable.
NOTICE: Do not crimp the cable.
9.
Remove the Resistance Sensor Magnet after noting the flat
segments are oriented up and downward. This will assist with re-
assembly.
Fender
Flywheel
Resistance Sensor
Magnet
38
Resistance Knob
Brake
Magnet
Brake Assembly
Resistance
Sensor
Hide quick links:
Advertisement
Table of Contents
