Nautilus Schwinn 800IC Service Manual page 92

Note: Your machine may not match the images provided exactly.
1.
Unplug the AC Adapter from the wall outlet and machine.
2.
Fully turn the Resistance Knob clockwise to lock the Flywheel into
place.
3. Disconnect the Console Cable from the Console Cable Connector.
4. Remove the Console Cable Grommet from the Frame Assembly.
5. Using a #2 Phillips screwdriver, loosen and remove the hardware
(indicated on one side by ovals) that attaches the Fender to the Main
Frame. Set the hardware safely aside for reassembly.
NOTICE: Hold the Fender so that it does not fall.
6. Remove the Fender from the front of the machine after noting how
the Resistance Cable routes through it. Place the Fender outside the
work area.
Fender
Resistance
Connection
Power Input Connection
92
Resistance Knob
Console Cable
Connector
Console Cable Grommet
Wiring Harness:
Console Connection
Speed Sensor Connection