Nautilus Schwinn 800IC Service Manual page 97

23. Connect the Power Inlet Cable to the Power Input Connector of
the Wiring Harness.
24. Gently pivot the Power Inlet Cable into place on the Frame
Assembly, and secure it to the Frame Assembly with the securing ring.
25. Gently pull the slack of the Console and Resistance Cables
upward out of the Frame Assembly, gradually feeding the Power Inlet
and Speed Sensor Connectors into the Frame Assembly.
26. Replace the Power Inlet Grommet. Be sure not to push it into the
Frame Assembly.
27. Replace the Speed Sensor Grommet.
NOTICE: Do not crimp the Cable.
28. Replace the Console Cable Grommet.
NOTICE: Do not crimp the Cable.
29. Connect the Resistance Cable.
NOTICE: Do not crimp the Cable.
30. Re-install the Fender, making sure the Resistance Cable is routed
between the Frame and the top of the Fender.
31. Connect the Console to Console Cable.
32. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled
and inspected for correct performance in accordance with
the Owner's Manual.
Fender
97
Resistance Cable