Nautilus Schwinn 800IC Service Manual page 68

10. On the right-rear side of the Handlebar Post, there is a small opening
(indicated by oval) where the Handlebar Bushing Tab is secured. Place
the end of a small standard screwdriver into the opening, and push the tab
in while pivoting upward the Bushing.
Handlebar Post Bushing
Handlebar Post
11. With the Handlebar Post Bushing released, place the end of the
screwdriver under the lip of the Bushing. Pivot upward until the Handlebar
Post Bushing is released. Continue pushing upward to remove the
Bushing.
12. Install the new Handlebar Post Bushing into the Frame Assembly. Be
Securing Tab
sure to orient the new Handlebar Post Bushing so the securing tab sets
into the small opening.
Handlebar Post Bushing
13. Re-install all remaining parts that were removed in reverse order.
14. If not replacing the Seat Post Bushing, skip to Step 21.
68