Secondary Swing Flap Motor - Daikin Sky Air FAA71BUV1B Service Manual

To remove the swing flap motor wiring harness
To install the swing flap motor wiring harness

4.8.2 Secondary swing flap motor

FAA71+100BUV1B
Sky Air indoor units
ESIE22-01 – 2022.02
Is the problem solved?
No
INFORMATION
For class 100 units: Main and secondary swing flap motor are connected to the same
wiring harness.
Prerequisite: Stop the unit operation via the user interface.
Prerequisite: Turn OFF the respective circuit breaker.
Prerequisite: Remove the required plate work, see
1 Disconnect the wiring harness from the main swing flap motor and secondary
swing flap motor (class 100 units ONLY).
2 Cut all tie straps that fix the wiring harness.
3 Route the wiring harness out of the retainers.
4 Disconnect the wiring harness from the indoor unit main PCB.
5 To install the swing flap motor wiring harness, see
INFORMATION
For class 100 units: Main and secondary swing flap motor are connected to the same
wiring harness.
1 Connect the wiring harness to the main swing flap motor and secondary swing
flap motor (class 100 units ONLY).
2 Route the wiring harness through the appropriate retainers towards the
indoor unit main PCB.
3 Connect the wiring harness to the indoor unit main PCB.
WARNING
When reconnecting a connector to the PCB, make sure to connect it on the correct
location and do NOT apply force, as this may damage the connector or connector
pins of the PCB.
4 Install new tie straps to fix the wiring harness as needed.
Is the problem solved?
Yes
No
INFORMATION
ONLY for FAA100B units.
4
|
Action
Return to the troubleshooting of the
specific error and continue with the
next procedure.
"4.6 Plate work" [
"Repair procedures" [
Action
No further actions required.
Return to the troubleshooting of the
specific error and continue with the
next procedure.
Components
4
60].
4
71].
Service manual
73