OPERATION MANUAL English SPLIT SYSTEM Air Conditioner Deutsch MODELS Français (Wall mounted type) Español FAQ71BUV1B Italiano ΕλληνικÜ Nederlands Portugues Russian...
The unit is individually operated. 1. WHAT TO DO BEFORE OPERA- NOTE • Contact your Daikin dealer in case of changing TION the combination or setting of group control and This operation manual is for the following systems two remote controller control systems.
When the air conditioner is to be installed in a 2. SAFETY CONSIDERATIONS small room, it is necessary to take proper mea- sures so that the amount of any leaked refriger- We recommend that you read this instruction man- ant does not exceed the limiting concentration ual carefully before use to gain full advantage of the even when it leaks.
Do not place items that might be damaged by HEATING water under the indoor unit. INDOOR OUTDOOR Water may condensate and drip if the humidity OUTDOOR UNIT TEMPERATURE TEMPERATURE reaches 80% or if the drain exit gets clogged. Do not place a burner or heater at a place –19.5 to 21 RZQ71 10 to 27...
• There are 2 ways of adjusting the air discharge • Operating procedure varies with heat pump type angle. and cooling only type. Contact your Daikin dealer to confirm your system type. • To protect the unit, turn on the main power switch 6 hours before operation.
MOVEMENT OF THE AIR FLOW FLAP Stop the horizontal flaps at a position where you can hold the tabs and adjust it left and right. For the following conditions, micro computer con- trols the air flow direction so it may be different from NOTE the display.
B)Washing with water 7. MAINTENANCE When the air filter is very (FOR SERVICE PERSONNEL) dirty, use soft brush and neutral detergent. ONLY A QUALIFIED SERVICE PERSON IS ALLOWED TO PERFORM MAINTENANCE Remove water and dry in the shade. IMPORTANT! • BEFORE OBTAINING ACCESS TO TERMINAL NOTE DEVICES, ALL POWER SUPPLY CIRCUITS •...
2. Remove the front panel. Cut off the power supply. Push the axes on either side of the front panel • When the main power switch is turned on, some towards the center of the main unit and remove. watts of electricity is being used even if the sys- (You can also remove it by sliding the front panel tem is not operating.
9. TROUBLE SHOOTING room becomes uneven. It is necessary to clean the inside of the indoor unit. Ask your Daikin I. If one of the following malfunctions occurs, dealer for details on cleaning the unit. This oper- take the measures shown below and contact ation requires a qualified service person.
Page 10
CODE Cooling effect decreases if heat gain of the room is too large. Measure: Notify your Daikin dealer and inform him/her of the display. II. If the system does not properly operate except for the above mentioned case, and none of the...