Plate Work; To Remove The Front Panel - Daikin Sky Air FAA71BUV1B Service Manual

4 | Components

4.6 Plate work

4.6.1 To remove the front panel

Service manual
60
b
c
a
a
a Tie strap
b Ferrite core
c Ground wire on power supply wiring terminal
d Indoor unit main PCB
2 Connect all connectors to the indoor unit main PCB.
INFORMATION
Use the wiring diagram and connection diagram for correct installation of the
connectors, see
WARNING
When reconnecting a connector to the PCB, make sure to connect it on the correct
location and do NOT apply force, as this may damage the connector or connector
pins of the PCB.
3 Connect the ground wire to the power supply wiring terminal.
4 Install the ferrite core on the ground wire.
5 Fix the ground wire and power supply wiring using new tie straps.
Is the problem solved?
Yes
No
DANGER: RISK OF ELECTROCUTION
Wait for at least 10 minutes after the circuit breaker has been turned OFF, to be sure
the rectifier voltage is below 10 V DC before proceeding.
1 Open the front panel. Hold the front panel by the panel tabs on both sides and
open until the panel stops.
d a
a
4
"7.2 Wiring diagram" [ 93].
Action
No further actions required.
Return to
procedures" [
main PCB and continue with the next
procedure.
"4.5.1 Checking
4
53] of the indoor unit
FAA71+100BUV1B
Sky Air indoor units
ESIE22-01 – 2022.02