Barco FSN-1004 User Manual page 68

3. Installation
Signal Connections
jìäíáîáÉïÉê=`çååÉÅíáçåë
The figure below illustrates monitor output connections on the MVR's rear panel:
LTC Input
Figure 3-14. Universal input connections
Please note:
•

Use the following steps to connect MVR outputs to your monitor(s).
1.
2.
3.
68
1
Multiviewer Output 1, DVI
(Digital only)
Multiviewer Output 1, SDI
Multiviewer Output 2, SDI
Multiviewer Output 2, DVI
(Digital only)
2
In both single and dual monitor configurations (as selected on the Multiviewer
Setup Menu), the same signal appears on both the DVI-I and BNC connectors.
In single monitor configurations, use DVI and/or BNC cables to connect the DVI
and/or SDI multiviewer output(s) to your monitor(s). The same signal appears on
outputs 1 and 2.
In dual monitor configurations:
~
Use DVI and/or BNC cables to connect the DVI and/or SDI multiviewer
Monitor 1 output(s) to your assigned "left" monitor(s).
~
Use DVI and/or BNC cables to connect the DVI and/or SDI multiviewer
Monitor 2 output(s) to your assigned "right" monitor(s).
If you want to display time on the Multiviewer from an external LTC source,
connect the output of your time code source (e.g., time code generator) to the
LTC Input as follows:
~
For a differential connection, use the +, – and GND terminals.
~
For a single-ended connection, use the + and GND terminals.
FSN-1004 • User's Guide • Rev 00