Table of Contents
Advertisement
6. Operations
Quick Setup and Operations
nìáÅâ=pÉíìé=~åÇ=léÉê~íáçåë
For the optimum speed in setting up and operating your FSN-1004 switcher, use the
following steps. For reference, links are provided to the appropriate sections in this guide.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Save system configuration — After completing all "system" setups, save the
11. Set up Multiviewer — As required, set up the Multiviewer and assign sources to
12. Set up memory registers — Set up the desired "looks" for your show, and store
184
Note
Many of these steps were already covered in Chapter 3 and
Chapter 5. As required, use the following list as an easy
check-list for all quick setup requirements.
Connect power — Ensure that power is properly connected to all FSN-1004
components.
~
Chapter 3, "
PC Connection
~
Chapter 3, "
System Connections
Connect inputs — Connect all input sources to the FSN-1004. (Chapter 3,
"
Signal Connections
," page 64.)
Connect outputs — Connect the output(s) of the FSN-1004 to your target
devices. (Chapter 3, "
Signal Connections
Turn on power — Turn on power to all FSN-1004 components, and to all
peripheral equipment. (Chapter 5, "
Factory reset — If you are using the FSN-1004 for the first time, or if you are
using a system that has just returned from another event, perform a full factory
reset. (Chapter 5, "
Return to Factory Default
Set output format — Set the desired output resolution and frame rate.
(Chapter 5, "
Output Format Setup
Enable test patterns — If required, use test patterns to verify outputs and make
the necessary adjustments. When complete, turn off the test patterns.
(Chapter 5, "
Output Test Patterns
Set up universal inputs — As required, set up all universal inputs, and perform
the necessary adjustments. (Chapter 5, "
Set up user preferences — Complete all user preference choices, as required.
(Chapter 5, "
User Preferences Setup
configuration and back up the system.
~
Chapter 5, "
Saving the Setup
~
Chapter 5, "
Backing up the System
Multiviewer PIPs. ("
Multiviewer Operations
them in memory registers as required. ("
page 189.)
," page 52
," page 55
," page 64.)
Power Up and Status Check
," page 167.)
," page 170.)
," page 171.)
Universal Input Setup
," page 180.)
," page 181.
," page 181.
," page 197.)
Working with Memory Registers
FSN-1004 • User's Guide • Rev 00
," page 166.)
," page 172.)
,"
Advertisement
Table of Contents
