Barco FSN-1004 User Manual page 119

`çååÉÅíçê=`çäçêë
On the Rear I/O Views of the UIC and M/E panels, the color of the individual input
connectors is significant:
•
•
•
•
The above "color" information is always available on the Input Menu and External DSK
Setup Menu . Press {Info} to display the Input Color Legend Pop-up :
Info
Note
Figure 4-49. Input Color Legend pop-up
FSN-1004 • User's Guide • Rev 00
Green indicates that the input is mapped to the GUI, and the signal is OK.
Red indicates that the mapped input has an " LOS " or " Invalid Signal " error. In
this situation, the input's Programmable Display turns red, and the red " Error "
button appears in the top right corner of the Touch Screen . Press the {Error}
button to learn more. Refer to the "
page 81 for details.
Note For the input connectors on the UIC , this " red " condition only
occurs if the input has been mapped to the panel, and the
signal was previously OK.
Note If desired, use the {Error Reporting} button to turn the red
error message off, and return the Programmable Display to
green. In this mode, the connector remains red. In
Chapter 6, refer to the "
section on page 186 for full details.
Yellow indicates that the input is un-mapped, and a signal is present.
White indicates that the input is un-mapped, and no input signal has been
detected.
Slot 1, Input 8:
Input color legend
Input mapped, signal OK
Input mapped, error or no signal
4. Menu Orientation
Notes and Error Messages
Understanding Error Messages
Close
Input un-mapped, signal present
Input un-mapped, no signal
System Menu
" section on
"
119