Barco FSN-1004 User Manual page 140

4. Menu Orientation
System Menu
•
•
^ìñ=jáñÉê=aÉëÅêáéíáçå
The FSN-1004 has two output modes for the Aux outputs on the M/E card . These modes
M/E Out
are selectable through the {M/E Out Type} button in the Out Setup Menu :
Type
•
Mixer
•
These two output modes apply only to the Aux outputs on the M/E card . The SOC card
outputs only operate in the Program (on-air) mode.
lìíéìí=pÉíìé=jÉåì=cìåÅíáçåë
The following functions are available in the Tool Bar :
•
Out
N a m e
•
Setup
140
PGM Name — this column indicates the Aux output's default on-line (or on-air)
program name (e.g., PGM 8-1 ), or custom name as defined with the {Out Name}
button. Custom names can be up to eight characters in length.
PVW Name — this column indicates the Aux output's default preview (or off-air)
program name (e.g., PVW 8-1 )
Mixer —In this mode, each pair of Aux outputs uses the odd-numbered output
(e.g., PGM 8-1 ) as the physical Program (on-air) output and the even-numbered
output (e.g., PVW 8-1 ) as the physical Preview (off-air) output. This output mode
serves as a personal-preference alternative to setting up Preview outputs in the
Multiviewer.
Pgm/Pvw —In this mode, each Aux output is the physical Program (on-air) output
for that channel. Preview for these outputs can be set up in the Multiviewer.
Press {Out Name} to associate a name (up to eight characters in length) with the
selected Aux output. When pressed, the pop-up Keyboard appears. Enter the
desired name and press {Enter} on the Keyboard . The name appears in the Aux
Table's " Name " column, replacing the default name. See the "
Keyboard " section on page 85 for details about the keyboard.
Press {Setup} to display the SOC Setup Menu . The button is grayed out when
Aux outputs are selected. Refer to the "
details on the setup menu functions for universal Aux outputs.
Using the Pop-up
SOC Setup Menu " section below for
FSN-1004 • User's Guide • Rev 00