Barco FSN-1004 User Manual page 46

2. FSN-1004 Orientation
Card Descriptions
4)
5)
6)
Figure 2-11. LTC Input connector
Please note:
•
46
MVR Output 1
In order to provide multiviewer connections to both SDI and DVI compatible
monitors, two connectors are provided for MVR Output 1:
~
1 x DVI-I
~
1 x BNC
The same output signal appears on both the DVI-I and BNC connectors. MVR
Output 1 can be used in both single and dual multiviewer monitor configurations,
as selected on the Multiviewer Setup Menu:
~
In a single monitor layouts, the selected layout appears identically on
MVR Output 1 and MVR Output 2.
~
In a dual monitor layouts, one half of the selected layout appears on
MVR Output 1, and the other half appears on MVR Output 2.
Please note:
~
The output resolution for both MVR outputs is set on the Multiviewer
Output Setup Menu, using the Output Format Keypad.
~
Both the BNC and DVI-I connectors can be active at the same time,
provided that the selected format is compatible. The valid combinations
are fully listed in the Output Format Keypad.
~
Refer to Chapter 7,
multiviewer setup details.
MVR Output 2
Output connections for MVR Output 2 are identical to MVR Output 1. See above
for details.
LTC Input
One Phoenix connector is provided for the Multiviewer's LTC (Longitudinal Time
Code) Input.
Two types of time code connections are possible:
~
For a differential connection, use the +, – and GND terminals.
~
For a single-ended connection, use the + and GND terminals.
Test patterns can be assigned to any MVR output, and a raster box can be turned
on or off. In Chapter 4, see the
"Multiviewer Operations" on page 197 for full
"Output Test Patterns
FSN-1004 • User's Guide • Rev 00
Menu" section for details.