Barco FSN-1004 User Manual page 176

5. System Setup
Aux Output Setup

Advanced Setup
1.
2.
3.
4.
5.
6.
7.

Sizing and Scaling
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Press {Back} to return to the Aux Setup Menu .
176
— Use the following steps to set advanced SOC output parameters:
On the Output and Process Panel , press {Advanced Output Setup} to display
the Advanced SOC Setup Menu .
Caution The Advanced SOC Setup Menu is designed for advanced
users who are familiar with all aspects of output timing
adjustments. Do not use this menu if you are uncertain about
any output timing parameter.
On the Advanced SOC Setup Menu , press the SOC Aux connector that you
want to set up.
Press {Totals} , and use the {H Total} and {V Total} controls to set the total
number of horizontal pixels and vertical lines in the output.
Important Changing the H and V Totals will cause a disruption to the
SOC's output video. Press {Apply} to apply changes, or
{Undo} to reverse un-applied changes.
Press {Active and Pos} , and use the {H Pos} , {V Pos} , {H Active} and {V
Active} controls to set the output's H and V active area, and the H and V position.
Press {Sync} , and use the {H Sync} and {V Sync} controls to adjust the output's
horizontal and vertical sync pulse width.
If the selected SOC output format is vertically locked to the native resolution's
vertical sync, press {Offset Timing} . Use the {H Offset} and {V Offset} controls
to adjust the SOC output's video timing relative to the system's native resolution.
Press {Back} to return to the Output and Process Panel , then press {Back} to
return to the Aux Setup Menu .
— Use the following steps to set up SOC sizing and scaling:
On the Aux Setup Menu , press the SOC Aux connector that you want to set up.
Press {Setup} to display the SOC Setup Menu for the selected output.
Press {Sizing and Scaling} to display the Output Sizing and Scaling Panel .
Press {Size and Position} , then use the {H Size} , {V Size} , {H Position} and {V
Position} controls to adjust the output's size and position.
If desired, in the Quick Adjust section, use the {Fill H} , {Fill V} and/or {Fill H/V}
controls to scale the output.
If desired, press {Aspect Ratio} , then select the desired aspect ratio in the
Aspect Ratio Pop-up .
To size and position the video within the boundaries of the output, press {Pan
Zoom Source} . Use the {Source H Size} , {Source V Size} , {Source H Pos}
and {Source V Pos} controls to size and position the video.
Press {Mask} , then use the {Mask Top} , {Mask Bottom} , {Mask Left} and
{Mask Right} controls to mask selected portions of the output, as required.
If desired, in the Output Mask Presets section, select the desired preset — and
remember that all mask presets in this section are additive.
FSN-1004 • User's Guide • Rev 00