Barco FSN-1004 User Manual page 65

lìíéìí=`çååÉÅíáçåë
Aux (auxiliary) buses are extra switching buses that allow video signals to be routed from
the FSN-1004 to external equipment. The figure below illustrates the Aux output
connections on the M/E card's rear panel, and the SOC rear panel:
Figure 3-12. Aux output connections

Use the following steps to connect Aux outputs from the FSN-1004.
1.
2.
Please note:
•
FSN-1004 • User's Guide • Rev 00
Aux Out 1
Aux Out 2
Aux Out 3
Aux Out 4
Aux Out 5
Aux Out 6
Using BNC cables, connect Aux Outputs 1 through 6 to your target auxiliary
devices or monitors. These six outputs run at the system's native resolution.
Use BNC, DVI or HD-15 cables (as required) to connect outputs to your target
devices. Use the Aux Setup Menu to set the output resolution for each SOC
output. In Chapter 4, refer to the
Use the Aux Setup Menu to map SOC Aux outputs to a GUI button, and name
Aux outputs (if desired). In Chapter 4, refer to the
on page 138 for setup details.
1
2
"Output Setup Menu" section for setup details.
"Output Setup
3. Installation
Signal Connections
Note:
Use the
Aux Setup Menu
to map
all SOC outputs
and set the
output resolution
Menu" section
65