Table of Contents
Advertisement
3. Installation
Card and Rear Panel
oÉ~ê=m~åÉä=fåëÉêíáçå
To insert a rear panel:
1.
2.
3.
4.
5.
6.
oÉ~ê=m~åÉä=oÉãçî~ä
To remove a rear panel:
1.
2.
3.
60
Use
Table 3-2
on page 59 to verify the slots in which the cards and their
corresponding rear panels can be installed. Front and rear slot numbers will
match. For example, if you install an SOC in front slot 13, its corresponding rear
panel must be installed in rear slot 13.
If a blank rear panel is installed in the target slot, loosen the two captive thumb
screws in the blank panel, remove it, and store it safely.
Ensure that the selected rear panel is properly oriented:
~
UIC: orient the label "1" at the top.
~
SOC: orient the label "1" at the top.
~
MVR: orient the label "1" at the top.
Using the nylon guides in the chassis for alignment, carefully insert the rear panel
into the chassis. Be sure to push on both the top and bottom thumb screws
simultaneously, until the card is fully seated in the chassis connector.
Caution
Always push both thumb screws simultaneously. If you only
push on one, you can damage the panel or bend a pin.
Once the panel is fully seated, tighten the two thumb screws.
Repeat from step 1 for all additional rear panels that you want to install.
Loosen the two captive thumb screws in the rear panel, and carefully remove it
from the FSN-1004 chassis. Store the panel safely for later use.
Install a blank panel in its place.
Important
Unused rear slots must always have blank panels installed.
Repeat from step 1 for all additional rear panels that you want to remove.
FSN-1004 • User's Guide • Rev 00
Advertisement
Table of Contents
