Table of Contents
Advertisement
2. FSN-1004 Orientation
Card Descriptions
2)
3)
4)
Table 2-2. UIC connector combinations for selected universal input formats
3G-SDI
HD-SDI
SD-SDI
DVI *
CVBS
Y/C
YPbPr **
RGsB
RGBS
RGBHV ***
5)
42
Card Power LED
The Card Power LED indicates power status for the card. Refer to the
LEDs" section on page 47 for details.
Loaded LED
The Loaded LED indicates the status of all FPGAs on the card. Refer to the
"Card
LEDs" section on page 47 for details.
Universal Input 1
Three connectors are provided for Universal Input 1 (1 x HD15, 1 x DVI-I, 1 x
BNC). Using these connectors, different combinations of inputs can be connected
to the FSN-1004, as outlined below, but only one of the three connectors can be
used at a time in the GUI.
Cells with check marks denote the connections required for the indicated format.
Format
BNC
* up to 165 MHz
** NTSC, PAL or HD
*** up to 165 MHz (UXGA)
Please note the following important points regarding the UIC:
~
Refer to the
"Analog Format Connection
additional information on using the HD-15 connector.
Universal Input 2
Input connections for Universal Input 2 are identical to Universal Input 1. Refer
to the explanation of Universal Input 1 for details.
Note
In Appendix A, refer to the
page 226 for details on UIC delay.
Connectors
DVI-I
HD-15
Table" section on page 48 for
"Delay
Specifications" section on
FSN-1004 • User's Guide • Rev 00
"Card
Advertisement
Table of Contents
