Bluetooth Status Display And Unpairing- Bluetooth Button; Alarm Status Display - Alarm Icon - Stiga Stig-A 1500 Instruction Manual

5.3.5. BLUETOOTH STATUS DISPLAY AND UNPAIRING- BLUETOOTH BUTTON
The "BLUETOOTH" button (M):
- It fl ashes blue if the robot lawn mower is available for pairing.
- It lights up blue if the robot lawn mower is connected to a mobile device.
The robot lawn mower automatically disconnects from the device when the app is closed.
The button (M) is used to disconnect the robot lawn mower in the event that the app of a second user is
unintentionally connected to the robot lawn mower.
Procedure:
1. Press the button "STOP" (A) to open the cover (B) and access the control console (C).
2. To disconnect the robot lawn mower from a mobile device, press and hold the (M) button for 3 seconds.
NOTE: For pairing the device with the robot lawn mower via Bluetooth, see Par. 4.7.3 "Pairing".
A
C D
5.3.6. DISPLAY OF ALARM STATES-ALARM ICON
The luminous "ALARM" icon (N) indicates an operating anomaly.
Procedure:
1. Press the button "STOP" (A) to open the cover (B) and access the control console (C).
2. Check the alarm status using the light icon (N):
- Green icon: indicates presence of special operational information;
- Yellow icon: indicates minor abnormalities;
- Red icon: indicates serious anomalies or malfunctions that may require assistance from the
service centre.
3. After resolving the fault, press the "ON/OFF" button (E) twice in rapid succession to reset the alarm.
The light icon (N) goes out, and the robot lawn mower can be restarted. If the icon (N) does not go
off , remove the safety key (D), wait a few seconds and then switch the robot lawn mower on again
using the "ON/OFF" button (E). If the problem persists, contact a service centre.
NOTE: Details of operational information or anomalies can be viewed on the App.
EN
B
M
5. OPERATION
45