Bluetooth ® Status Display - Bluetooth ® Button; Display Of Alarm States-Alarm Icon - Stiga A 500 Instruction Manual

5.3.5. BLUETOOTH
®
The robot lawn mower handles automatically the Bluetooth
Bluetooth connection is available at all times when the robot lawn mower is switched on. It is possible to
®
connect only one mobile device at a time to the robot lawn mower via Bluetooth
automatically disconnects from the device when the app is closed. The 'BLUETOOTH
only by the service centre for diagnostic purposes.
NOTE: For pairing the device with the robot lawn mower via Bluetooth
A
C D

5.3.6. DISPLAY OF ALARM STATES-ALARM ICON

The "ALARM" light icon (N) indicates an operating anomaly.
Procedure:
1. Press the "STOP" button (A) to open the cover (B) and access the control panel (C).
2. Check the alarm status through the red light icon (N), which can be lit either steady or flashing.
3. After resolving the fault, press the "ON/OFF" button (E) twice in rapid succession to reset the
alarm. The light icon (N) goes out, and the robot lawn mower can be restarted. If the icon (N) does
not go off, turn off the robot lawn mower using the "ON/OFF" button (E), wait a few seconds and
then switch the robot lawn mower on again using the "ON/OFF" button (E). If the problem persists,
contact a service centre.
NOTE: Details about anomalies are viewable on the App.
EN
STATUS DISPLAY - BLUETOOTH
B
BUTTON
®
connection with external mobile devices. The
®
. The robot lawn mower
®
' button (M) is used
®
, see Par. 4.7.3 "Pairing".
®
M
5. OPERATION
55