Installation Requirements Check; Garden Assessment; Checks For The Installation Of The Charging Base And Power Supply - Stiga Stig-A 1500 Instruction Manual

4.3. VERIFICATION OF THE INSTALLATION REQUIREMENTS
The procedures to check the necessary requirements and prepare the garden before proceeding with the
installation are described below.
4.3.1. GARDEN VERIFICATION:
• Carry out a survey of the entire area for a correct detection of the state of the garden, any
obstacles and areas to be excluded.
• Check that the lawn to be mowed is uniform, free of holes, stones or other obstacles and, if
necessary, carry out the appropriate environmental decontamination works.
NOTE: Level the ground so that no puddles form as a result of rain.
NOTE: At the first installation, the initial height of the grass must be within the operating range
of the robot lawn mower: 20-60 mm. If necessary, prepare the garden using a traditional lawn
mower.
4.3.2. CHECKS FOR THE INSTALLATION OF THE CHARGING BASE AND POWER SUPPLY:
ELECTRICAL HAZARD:
A socket must have been prepared
near the installation area to connect
it to electricity. Make sure that
connection to the power supply
network conforms to laws in force of
the Country where it is used.
ELECTRICAL HAZARD:
The circuit provided must be protected
by a residual current device (RCD)
with an activation current not
exceeding 30 mA.
Procedure:
1. Prepare a levelled area to set up the charging base (A), preferably in a part of the garden where the
sky is fully visible and close to an electrical outlet.
2. Make sure there is enough room to install the charging base, allowing a clear strip of ground at least
1.5 meters wide and 3 meters long in front of it. The ground must be perfectly flat and compact in
order to avoid any deformation of the charging base surface.
3. If the charging base (A) is not placed in an area where the sky is fully visible, the satellite reference
station (B) must be removed from the charging base and placed in an area where the sky is fully
visible. The connection to an electrical outlet is required.
EN
ELECTRICAL HAZARD:
Do not connect the power supply to
an electrical outlet if the plug or the
cable is damaged.
Do not connect or touch a damaged
cable before it is disconnected from
the power supply.
A damaged cable can lead to
contact with live parts.
4. INSTALLATION
15